July 4, 2013
Happy Fourth of July, Everyone!
We decided that since our bees have been so productive this year, we’d go ahead and harvest a little honey. Actually, I was going to wait until my normal time, the end of August, but I bumped into a friend at Rainbow Co-op Grocery who is also a beek, and he said he was already harvesting.
I said, “Isn’t it a little early?”
He said that he was running out of supers. I got to thinking about it, and figured, well, why not? I plan to adding the super back, anyway. Just trade it out now and see how they’re doing in the fall. As long as they have adequate honey for winter, skimming some off the top now shouldn’t hurt.
So, I’ve just come back from preparing to harvest a little honey. Not a lot: just a little. Note, we didn’t actually harvest honey today. But we’ll have some, hopefully, in a couple of days. This is just the preparation.
A lot of folks, I guess, think that you just go out to the bees and they give you honey. It’s not that easy. Actually, you have to separate the bees from the honey. And that can be messy — or it can be rather gentle.
Since I’m a natural beekeeper — barefoot beekeeper or whatever you want to call it — I prefer nonchemical, easy and gentle.
In the old days, when I started beekeeping back in the 1970s, we would use “fume boards.” They were stinky arrangements where you dosed a board with a stinky substance that the bees — and beekeepers! — couldn’t abide. That caused the bees to leave the box adjacent to the board, and the beekeeper removed the box.
But somewhere along the way, somebody got smart and developed an excluder board that does the same thing — separating bees from honey — without the stink. It’s a board with a hole in it that’s covered in a screen arrangement, so that the bees can go back down into the main hive at night but are prevented from getting back into the box when they try to return in the morning.
So, today, I put in the excluder. Here’s a step by step.
First, you want to gather some pine straw for your smoker. Some companies sell material to be burned in bee hive smokers, but why spend money when there’s a natural substance that’s free? One caveat: I’ve learned the hard way not to just go out to the pine trees and start gathering straw to be used that day. Sooner or later, you’ll find yourself wanting to mess with the bees and the pine straw will be too damp to use.
Rather, I keep a bucket in the garage with gathered pine straw in it. That way, the pine straw is always dry. When the bucket starts to get low (pictured), I just take it with me and fill it up along with as much as I need for that day, and bring it back to the garage when I’m through.
Pine straw works pretty good. Take some newspaper and tear it into strips and put them in the middle of a handful. Light the paper and once it starts burning, stuff it into the smoker. Puff it a couple of times to make sure it’s well lit, then close the top. You should be good for a session in the bee yard. But always carry a lighter, just in case. It doesn’t take but a moment to relight the smoker if it goes out.
Here’s the smoker in the bee yard. Another tip: It it seems to be going out, only lightly use the bellows. Don’t pump it hard. That will almost certainly cause a dwindling spark to go out. Rather, gently squeeze the bellows in slow, long steps. You’ll see the smoke gradually get thicker. Then, if you set it down, it may get thicker still.
We’re going to install the excluder in the established hive (not the swarm hive) on the right. We’ll get back to the swarm hive in coming weeks.
As you can see, the bees have been busy. It’s only been 10 days since we put this super on the hive, but the bees have built wax all the way to the the end frames and have actually started putting honey in the center frames.
So, I took off the top super off and set it to the right, as you can see in the photo. The top of the hive and inner board are on the ground to the left. Next, I pick up the super that’s now shown as the top one (the one covered with bees) and set it on the saw horses, on the right. I put the newest (green) super where it had been, and put the excluder board on top of it. Then, I put the hive full of honey on top of the green super, with the inner board and hive top on top of that. Here’s a photo:
So, now, the hive box filled with honey — and believe me, it’s filled with honey, maybe 50 pounds — is the top box. You can see the brown line beneath it that is the excluder board.
We’ll come back Saturday and check and see if it’s empty of bees. If so, we’ll take the box and remove the honey. If there are still some bees in it, we’ll give it another 24 hours.
Using the old stinky fume boards was quicker. But I’m grateful that this method has been developed. I don’t mind waiting for honey, or for the bees to very gently be removed from their honey. I think it’s just good energy! Right now, they’ll be focused on filling that new box with honey and will forget about the top box.
Now, we’re ready to celebrate! This EXCLUSIVE Fourth of July, in hopes of sweeter times, still!!!
Jim PathFinder Ewing is a journalist, author, writer, editor, organic farmer and blogger. His latest book titled Conscious Food: Sustainable Growing, Spiritual Eating (Findhorn Press) is in bookstores now. Find Jim on Facebook, follow him @edibleprayers or visit blueskywaters.com.